Ford Fusion V6 Sport Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
760 Posts
Im new to this and while installing steeda cold air intake(which has been a nightmare so far) 2 plastic clamps holding the tubes broke and fell into the bay kinda close to the block. Is there any risk to them staying there? I'm also sure I found a 3rd piece down there as well
Hi Blackhalo. Just sitting down there in the open, in the engine bay? No, they would not be dangerous. However, what are you doing to replace the clamps? Be sure to replace them and properly secure things.

If it were my car, I would try to get the pieces out, if only due to a bit of OCD...lol

However, if you can not, don't worry about it.

Let us know how you make out and good luck.
 
1 - 1 of 1 Posts
Top