Ford Fusion V6 Sport Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Im new to this and while installing steeda cold air intake(which has been a nightmare so far) 2 plastic clamps holding the tubes broke and fell into the bay kinda close to the block. Is there any risk to them staying there? I'm also sure I found a 3rd piece down there as well
Automotive tire Gas Engineering Machine Automotive wheel system

Automotive tire Black Tire Tread Motor vehicle
 

·
Registered
Joined
·
760 Posts
Im new to this and while installing steeda cold air intake(which has been a nightmare so far) 2 plastic clamps holding the tubes broke and fell into the bay kinda close to the block. Is there any risk to them staying there? I'm also sure I found a 3rd piece down there as well
Hi Blackhalo. Just sitting down there in the open, in the engine bay? No, they would not be dangerous. However, what are you doing to replace the clamps? Be sure to replace them and properly secure things.

If it were my car, I would try to get the pieces out, if only due to a bit of OCD...lol

However, if you can not, don't worry about it.

Let us know how you make out and good luck.
 

·
Registered
2017 Blue Lightning
Joined
·
50 Posts
Maybe a long screwdriver to knock them out, or one of those push button claw thingies. (That is the official scientific name for it, btw 😜)
 
  • Haha
Reactions: Gregg1LE

·
Registered
2017 Ford Fusion Sport
Joined
·
213 Posts
Maybe a long screwdriver to knock them out, or one of those push button claw thingies. (That is the official scientific name for it, btw 😜)
You Marines😉 . Its an Extended Claw Retrieving Tool 🤣.
 
1 - 6 of 6 Posts
Top